Faucets are an indispensable part of a home structure and keeping them in a good working condition is imperative. A leaky faucet not only disturbs sleep and adds to the water bill but also causes an inconvenience that might range from annoying to catastrophic. The typical causes for a leaky faucet include corrosion, mineral deposit on the internal parts, or defective gaskets, o-rings, or washers. Luckily, most faucets that leak can be fixed by homeowners if they have the right tools and some basic knowledge of plumbing. Ignoring a faulty faucet can turn a simple repair of $200 into a $1,000 plumbing replacement project. Besides, a dripping faucet leads to a waste of over a hundred gallons of water every month.
The United States Environmental Protection Agency reveals, “On an average, leaks can cause almost 10,000 gallons of wastage in a home every year, and this amount is sufficient to fill a swimming pool. The most common issues of leakage are a dripping faucet, leakage in toilet flappers, or leaking valves, all of which can be easily fixed. However, among these, the most prominent leakage issue is caused by a dripping faucet; fixing one can save almost 10% of a homeowner’s water bill.”
There may be several reasons behind why your faucet is dripping. Below we review some of the most common causes of a leaky faucet.
A stem screw is used to hold the handle of a faucet in place. This stem screw includes a small disc attached to it, known as the O ring. This is an integral place where dripping can occur. However, the O ring can become loose or wear out over regular use, causing the faucet to drip near the handle. Replacing the damaged O ring will fix it if this is the issue. This problem occurs specifically in cartridge faucets.
A valve seat serves as a connection between the faucet and the spout in the compression mechanism. Accumulation of water sediments can cause the valve seat to corrode, thus, causing leakage around the spout area. Make sure that you clean the valve seat regularly with the help of a professional plumber. Call Hansen’s Plumbing.
This is one of the most common causes behind a dripping faucet. During each use, the washer is forced against the valve seat, and this constant friction causes it to wear out. As a result, dripping is noticed around the spout. Dripping caused by worn-out rubber washers can be mended by replacing the washer. This type of leak is found in a compression faucet.
Often, if the washer is not installed properly or is not the right size, thus, it can cause a leaky faucet. We suggest hiring a professional plumber to help you install the washer properly, allowing you to say goodbye to your leak.
The internet is a powerful resource. You can learn how to play the guitar from online tutorials, get the fastest, first-hand coverage of breaking news, and stay in touch with those we love even when we can’t see them in person. While the internet is an amazing asset to our culture, it does have its limitations. If you’re trying to become an expert plumber in just a day’s time because you want to clear a pipe it’s time to call a plumber near me. We discourage DIY efforts in almost any context when it comes to your plumbing. That’s because this system is so complex that it needs professional care. If you’re looking for a plumber near me to help you with your plumbing then make sure that you contact our team at Hansen’s Plumbing.
So now you’re probably wondering, “Do I really need to hire a plumber near me?” The answer is yes! We know that this may seem a little biased coming from a team of professionals, but trust us, we see the aftermath of a lot of DIY attempts and they’re bad. You can do some real damage to your plumbing system. You might think that you’re saving yourself money by doing this, but in reality, all you’re really doing is making the path to finding relief with your plumbing system much longer than it needs to be.
As a homeowner, you probably have the necessary tools to fix a partial clog, but we can assure you that you don’t have a professional grade hydro-jet to clean your draining system. Our professional plumbers combine their expertise, education, and an extensive number of tools to fix your drain problems in a snap.
If you’re fighting a clog inside your sink or bathtub, or you’re feeling crushed after failed efforts to unclog drains, it’s time to reach for the elbow grease and unleash your true drain cleaning potential. Hansen’s Plumbing is here to help.
Clogged drains are a common problem. Causes could range from food getting stuck in your garbage disposal to foreign objects in the drain or a build up of hair in the bathtub.
Whatever the source, use these tips to unclog drains:
A clogged drain can be remedied with the tools you have in your own home. Instead of throwing out that old metal hanger in your closet, try transforming it into a drain cleaning tool. Simply straighten the hanger and bend the tip into a hook so you can grab whatever is lodged in the drain.
If the old hanger trick is failing you, reach for the plunger. Yes, your plunger can be used in places other than your toilet. Be certain your sink or tub has a few inches of water inside, and plunge away. However, make sure the plunger has water inside and not air, as this will yield more success.
Still stuck? Now’s the time to find your wet/dry vacuum. But before you start, you might want to grab a few old towels or sheets to protect the floor and furniture around you — this could get messy. Create a tight seal and get to work.
Don’t let harsh chemicals be your last resort as you attempt to clear your clogged drain. In fact, the chemicals could even be making the clog worse if they sit atop the clog. They also pose health risks to you and those around you. Especially if you’ve already dumped chemical drain cleaner down the drain, adding other liquids could cause dangerous reactions.
Instead, opt for natural alternatives, ask Hansen’s Plumbing about environmentally friendly drain cleaners.
Perhaps the problem is worse than you thought. If you’re unsuccessful in your unclogging efforts, let the experts take the reins. Besides, if you’re not careful with your own efforts, you could end up damaging your pipes or actually make the problem worse.
Hansen’s Plumbing is ready to take on your challenge. Our punctual plumbers have the tools and expertise to unclog drains and get your home’s plumbing system working properly again. We’re available 24 hours a day, 7 days a week. Give Hansen’s Plumbing a call for your plumbing needs in California.
When Do You Need to Change Your Water Heater?
A deteriorating water heater isn’t an issue until you take your first icy cold shower. Now comes the big question: repair or replace? How do you know if your water heater is just acting up or burned out for good? Take a look at a few tips below to determine when you need to call Hansen’s Plumbing.
Changing your water heater is definitely something you don’t want to wait too long to do, as costly water damage can occur. Here are some signs to look for to determine if your water heater needs to be replaced.
As a rule of thumb, water heaters should be changed every 6 to 12 years. After this point it can begin having issues and start deteriorating. To avoid costly water damage, be sure to observe the signs below so you will know when to call Hansen’s Plumbing to change out your water heater.
One of the most obvious signs is when you turn on your shower and the water doesn’t get warm. Cold water is the first sign that something is wrong. If it’s an old unit, most likely you need to change it out.
Most people assume their water heater is working fine until they experience cold water. Yet, age is not the only sign that it needs to be replaced. Your water heater could be older and still work perfectly fine. It’s important to pay attention to signs that your heater is deteriorating such as leaks and a rusty color.
If your hot water is a rusty color, this is a clear warning sign that your water heater is corroding and needs to be replaced. When your tank rusts, the rust gets into the water and turns it a dirty brownish color. Yet, this also could be an issue with the public water supply or corroding iron plumbing. To test this, simply turn on the cold water. If it is the same rusty color then, most likely it’s due to an external factor.
If your tank is leaking, it’s an obvious sign that it’s time to get your water heater replaced as soon as possible to avoid water damage. Because it is usually an internal issue, it is rarely fixable and is best to replace.
If it isn’t flushed once a year, sediment builds up inside and this will eventually result in irreversible damage. When it reaches the point where water won’t drain then it can’t be repaired and will need to be replaced.
Once a year, having the heater tank flushed to remove sediment will help it last longer. Another thing to check is the anode rod. This collects corrosive elements and should be checked about every three years and replaced if needed.
Oxnard Plumbing Tips
No one likes the thought of plumbing repairs. Some mild plumbing issues can be solved with a plunger and a little bit of elbow grease. There comes a time, however, when do-it-yourself repairs will not address the issue and you need the services of a qualified professional to get the job done. The key word there is “Professional.”
So, let’s be honest. We don’t schedule plumbing appointments months in advance. Plumbers are the ones we frantically call at 2 a.m., with water pooling up around our ankles and towels strewed across the floor. We call a plumber at mid-melt-down, and somehow, they have to explain the inner workings of our pumps and valves in plain English and jump into action before damage is done. When looking to hire an Oxnard Plumber, (Hansen’s Plumbing) you want someone who will do the job right the first time, who will charge a reasonable rate for his or her services and who will treat your home like it was his/her own.
Tips on Hiring the Right Plumber
Appropriate Licensing and Insurance
One of the first things that you need to consider before hiring a plumber is whether or not they are licensed and certified by the state they work in.
Each person in the plumbing business should have a valid license to allow him or her to work in the field. Regardless of the size of your plumbing project, you should never trust an individual who fails to produce his or her working permit. The license proves that the professional has met the required standards set by the authorities to serve clients in the region.
A good plumber will be insured and bonded in the event of a mishap: protecting not only your home but the plumber himself as well.
Experience is a paramount factor to consider when looking for a professional plumbing service. It is advisable to check the length of time the plumbing company you are planning to hire has been in business. New professionals may fail to meet your plumbing needs.
If you’re in need of a plumber, you should not hesitate to ask your friends, family members, or workmates to recommend you the best plumbing company in the region. Some of your colleagues may have worked with experienced plumbers in their homes. They will share experiences, which will help in making an informed decision. Any reputable plumbing company should be able to provide references with ease, so do not hesitate to ask.
Always ask for an in person estimate. Just as a doctor could never diagnose a patient over the phone, an honorable plumber cannot determine the scope of work over the phone either. Keep in mind that quality comes at a price. A licensed skilled and experienced plumbing company may charge more than an unlicensed plumber, but you can almost always guarantee that they will do a better job and not cut corners.
When it comes to hiring a plumber, the experts at Hansen’s Plumbing possess all of the qualifications you need. We’ve been in business since 1987. Good plumbers that keep their customers best interest in mind are hard to find. This is the reason Hansen’s Plumbing was started. Make sure to keep the above tips in mind to ensure that the plumber you hire is not only experienced at their job, but that they can also solve your plumbing issues quickly and properly.